How to install a wiper motor pulse board?

Posted on October 12, 2009 by admin

How do you install a wiper motor pulse board on a 88 Chevy sliverado step side? Do you need to take the wiper motor off to do it? Please give me some clear directions.

No need to remove the motor, just the cover. Unplug the wire connector then the three screws pull the cover then the board. Put the new board on then replace the cover and the wire connector and the repair is complete.

This entry was posted in pulse. Bookmark the permalink.

2 Responses to How to install a wiper motor pulse board?

  1. Vince J says:
    October 12, 2009 at 3:10 pm

    No need to remove the motor, just the cover. Unplug the wire connector then the three screws pull the cover then the board. Put the new board on then replace the cover and the wire connector and the repair is complete.
    References :

  2. wibll1 says:
    October 12, 2009 at 3:23 pm

    I agree with Vince J.It is very easy.You should have no problems.Just refer to Vince J’s answer.
    References :