Pulse Motor Reed switch type @ 250 mA draw ..!! :O

Posted on April 1, 2010 by admin

chargeing a battery or make hydrogen & oxygen with my magnet pulse motor :) back EMF\radiant spike goes to my battery or my HHo cell . after makeing HHo i got a charge of 2-3volts over my cell long time after its disconnected from my pulse motor under load i got aprox . 7-12 volts over my cell and its makeing HHo well , haven`t measured the output L\min yet but i\ll shall do that ASAP , but then with my SG setup and “coil\helix” setup on the HHo cell .

Duration : 0:1:0


[youtube EcTN6LrTSN0]

This entry was posted in pulse oxygen and tagged , , , , , , , , , , . Bookmark the permalink.

One Response to Pulse Motor Reed switch type @ 250 mA draw ..!! :O

  1. dodoshlodo says:
    April 1, 2010 at 5:16 am

    nice 1, its similar …
    nice 1, its similar to mine