Reactor Series Class D Monoblock Car Amplifier
# RMS Power Rating:
* 4 ohms: 500 watts x 1 chan.
* 2 ohms: 700 watts x 1 chan.
# Max power output: 1800 watts x 1 chan.
# Pulse width modulated (PWM) MOSFET power supply
# Wired remote bass level control included
# LED power indicators
# Selectable bass boost (0, 6, 12 dB at 45 Hz)
# MIL-Spec Fiberglass Circuit Board
# Single channel operation
# SMD Technology
# High level input
# Preamp RCA outputs
# 3 Stage Protection Circuit
# Compact chassis design
# High rail voltage
# Centered low-pass filter (80 Hz, 18 dB/octave)
# Frequency response: 50-150 Hz
# Dimensions: 11.7"L x 11"W x 2.3"H
I would suggest running 2, 2-Ohm, Dual Voice Coil Subwoofers, with 300-400 Watts RMS each. I would suggest alpine type s’s, kicker cvr’s, or if ur looking for something a little more rockford punch stage 3′s.
The most power you will get from that amp will be running 2 2-ohm DVC subs, or a single 4-ohm DVC sub (kicker cvx, kicker L7, alpine type-r)
I would suggest running 2, 2-Ohm, Dual Voice Coil Subwoofers, with 300-400 Watts RMS each. I would suggest alpine type s’s, kicker cvr’s, or if ur looking for something a little more rockford punch stage 3′s.
The most power you will get from that amp will be running 2 2-ohm DVC subs, or a single 4-ohm DVC sub (kicker cvx, kicker L7, alpine type-r)
References :
Run that to 3 12"inch p1 subs in a ported box, it’ll be cheaper and give you the bump you want.
References :
Pingback: SHOP ELECTRONICS!!!