I just bought 4 subs these are the specs for them:
* AA BASS12
* 2-Pair (4 single) 12” High Performance Subwoofers
*
* Designed and Engineered in USA
* Power Handling Capabilities:
* 1600 Watts RMS to 3200 Watts Maximum Per 2-Pair
* 800 Watts RMS to 1600 Watts Maximum Per Pair
* 400 Watts RMS to 800 Watts Maximum Each
* Recommended Power:
* 120 Watts to 3200 Watts Per 2-Pair
* 60 Watts to 1600 Watts Per Pair
* 30 Watts to 800 Watts Each
* 2” Parabolic RFL Voice Coil
* 60 oz. Magnet
* Oversized Rubber Surround
* 4 Ohm Impedance
* Poly Zirconium Cone
* Efficiency / Sensitivity 98dB @ 1 Watt / 1 Meter
* Polyimide Voice Coil Former
* Mid Q Design for Versatility in Enclosure Compatibility
* Flat Progressive Roll Spider
* CEA Cooling Technology
* Vented and Extended Pole Piece
* Low Carbon Top and Bottom Plate
* Weather Resistant Design
* Approved for Car Audio and Marine Use
* 3 Year Warranty
I wanted to know would the POWER ACOUSTIK OVN1-5500D MONO be a good amp to buy for these speakers the specs:
Hi Speed Digital Circuitry
New Hyper Bass
1 Ohm Stable
Remote Dash Mount Low Level Gain Control w/ Cable
PWM Power Supply
4-Way Protection Circuit
Bridging Synchronization
Variable Bass Eq 0dB-18dB @ 45Hz
Phase Switch 0 or 180
Frequency Response : 20Hz – 200Hz
S/N Ratio : 100dB
THD : 0.5%
Master/Slave Function
System Distress Indicator
Dual Mono Speaker Output Connectors
Platinum Plated Heavy Duty Power & Speaker Terminals
Maximum Power : 5500 Watts
RMS Power Output @ 4 Ohms : 1700 Watts x 1 Channel
RMS Power Output @ 2 Ohms : 2500 Watts x 1 Channel
Bridged Power : N/A
THD (Total Harmonic Distortion) : 0.5%
Signal-to-Noise Ratio (dB) : 100dB
Built-in Crossover : N/A
Subsonic Crossover Frequency : 20Hz-50hz
Low-Pass Crossover Frequency : 40Hz~200Hz
Bass Boost : 0dB~18dB
Bass Remote : Yes
Fan Cooled : N/A
Fuse Rating : N/A
Dimensions (Width x Height x Depth) Inches : 17.1" x 8.26" x 2.16"
or should i buy the POWER ACOUSTIK OVN1-5500D MONO?
The Specs:
Gothic Series Class D Monoblock Car Amplifier*
RMS Power 4 ohms: 1700 watts x 1 chan.*
RMS Power 2 ohms: 2500 watts x 1 chan.*
RMS Power 1 ohm: 3200 watts x 1 chan.*
Max power output: 5500 watts*
MOSFET power supply*
Wired remote bass level control included*
LED power indicators *
0-18 dB Bass Boost: 45 Hz *
180 Degree phase shift *
Pulse width modulation circuitry*
Mono channel operation*
Bridged Synchronization*
Strap amps together to double power*
Preamp RCA outputs*
3-Way system protection circuitry (short, thermal, overload)*
Gunmetal gray anodized finish with chrome accents*
Heavy duty aluminum alloy heatsink*
RCA level inputs*
Screw terminals*
Low level inputs (200mV-8V)*
Variable low-pass filter (40-200 Hz, 12 dB/octave)*
Subsonic Filter (12 dB at 20-50 Hz)*
Frequency response: 15-150 Hz*
Dimensions: 19-1/8"L x 10-5/8"W x 3"H*
1 Year Manufacturer Warranty
or is this to much power should i go with a less wattage and when i get tweeters do i have to purchase a whole other amp or can i hook them up to the same amp as my 4 subs?
sorry the 1st amp SPECS are for a POWER ACOUSTIK 5500W BAMF series the 2nd is for a Gothic series
These are 1 channel amps your going to need 2 amps if your going to buy one of these models.I would go with op. 2. 2 of dem
November 26th, 2009 at 9:36 am
These are 1 channel amps your going to need 2 amps if your going to buy one of these models.I would go with op. 2. 2 of dem
References :